Home > See All >

Micro Jig Deflector/Connector for the GRR-Ripper
Micro Jig Deflector/Connector for the GRR-Ripper
 
Alternative Views:
Ties together two GRR-Ripper units for working with longer lumber or to block debris when using a single unit. Requires GRHB-010 Handle Bridge; fits all GRR-Ripper models.
Our Price: $13.95


Estimated availability: Usually Ships in 1 to 3 Business Days
Product Code: MJGRDC-020

Description
 
Micro Jig Deflector/Connector for the GRR-Ripper

Used in conjunction with the Handle Bridge (GRHB-010), Micro Jig's Deflector/Connector serves a couple of functions within the GRR-Ripper system.The most obvious benefit is that it allows connecting two GRR-Ripper units end to end for working with longer lumber or side by side for machining wider panels.Using two Deflector/Connectors allows an even wider spacing when connecting two units side by side.

When used with a single GRR-Ripper, the Deflector/Connector also serves as a supplementary guard or shield extending off the side or the end of the GRR-Ripper body.Attached to the side of the body, it helps deflect chips that can be thrown upward from a router bit.Attached to the end of the body when used at the table saw, it helps cover the exposed blade at the end of a rip cut.

Works with all GRR-Ripper models; GRR-Ripper Handle Bridge (GRHB-010) required.


Browse for more products in the same category as this item:

See All
See All
See All > GRR-Ripper Safety System
See All > GRR-Ripper Safety System
Hold Downs